Top COAT opaque effect?

A top coat to mattify the polish semi-permanent without using the file, let's find out!

For traditional enamels there is no problem, just put a top coat effect, but for the polish semi-permanent?

How to achieve a matte effect without using the file?

How to mattify polish semi-permanent in one simple gesture?

NEW - TOP COAT MATTE by LCI Find out



Use

Nail preparation Accessories: Gloves - Lima - Tronchesina - Finishing block - Push cuticles - Pressed cotton pad - Disinfectant - fluidpro®

Let's put on the gloves and get started.

1 We vaporize the customer's tools and hands with the disinfectant. We dry our hands well with a towel.

2 With tronchesine, we cut the excess cuticles

3 We push the small cuticles along the perimeter of the nail, using the cuticle push or orange stick

4 We use the file (side 180) to give the preferred shape to the nails

5* We take the finishing block and evenly mattify the nail

6* Now with a cotton pad moistened with fluidpro, we clean the surface of the nail from the dusty residues

Application of the semi-permanent LCI

Accessories: Color - BASE - TOP - Pressed cotton pad - Cleaner - fluidpro® - UV lamp or LED - Cuticole oil

7* We apply a THIN and HOMOGENEOUS layer of BASE, taking care not to touch the cuticles. The BASE DRYFIX will not release dispersion.

8* We catalyze in UV lamp for 120 sec. (in LED lamp 60 sec.)

9* We apply the first layer of color ( we recommend 3 total layers). Here too, we try not to dirty the cuticles and apply it in a homogeneous and subtle way. We catalyze in UV lamp for 120 sec. (in LED lamp 60 sec.) THIS POINT, LET'S REPEAT IT 3 TIMES (3 layers of color)

10 Now we are ready to apply the TOP. We make a homogeneous, thin layer and catalyze in UV lamp for 240 sec., i.e. 2 timer cycles (in LED lamp 120 sec.). The TOP DRYFIX will not release any dispersion when used in the right way, but we can still polish with a little lightly moistened pressed cotton of Cleaner LCI.

11 At this point we can apply cuticles oil, distributing a small amount on the perimeter of each nail. We gently massage our fingers and compliments, we finished our manicure with semi-permanent!

USEFUL TIPS

5* Be careful not to leave any part of the shiny nail. We always check the backlight that the surface is all completely opaque.

6* Attention, after completing this process we never touch the nail again for any reason, we could fatten it again and this will create possible problems of future tightness.

7* We do not leave any part of the nail not covered by the base. Let's check, here too, looking at the backlight surface. I recommend that it be a thin layer, otherwise, a thick layer could give problems of color duration.

8* Be careful to place your hand well, so that all fingers are evenly facing under the range of the bulbs. We don't bend our thumbs much, but we try to lay it out as best we can.

9* We must not be in a hurry to see a completely covering effect right away, we last all the steps well. If we dirty the cuticles or skin, we clean with the orange stick moistened with fluidpro before catalyzing in the lamp.

IMPORTANT: Apply the product (base, color, top) also on the tip of the nail before catalyzing in the lamp (TIP CLOSURE technique). This will guarantee a long duration of the polish.

Comments (0)

There are no comments at this time

New comment

Product added to wish list